1
Introduction
The NX-series Load Cell Input Unit Startup Guide for Weight Measurement (hereinafter, may be
referred to as “this Guide”) describes the startup procedures for weight measurement in
combination with the NJ-series CPU Unit and the basic operating instructions for the Sysmac
Studio. A simple scaling system is used for the discussion. You can perform the procedures that
are presented in this Guide to quickly gain a basic understanding of how to use the Load Cell
Input Unit.
This Guide does not contain safety information and other details that are required for actual use.
Thoroughly read and understand the manuals for all of the devices that are used in this Guide to
ensure that the system is used safely. Review the entire contents of these materials, including
all safety precautions, precautions for safe use, and precautions for correct use.
Intended Audience
This Guide is intended for the following personnel.
• Personnel in charge of introducing FA systems
• Personnel in charge of designing FA systems
The personnel must also have the following knowledge.
• Knowledge of electrical systems (an electrical engineer or the equivalent)
• Knowledge of NJ-series CPU Units
• Knowledge of operation procedure of Sysmac Studio
• Knowledge of NA-series Programmable Terminal
• Knowledge of load cells
Applicable Products
This Guide covers the following products.
• Load Cell Input Units of NX-series Machine Automation Controllers
• CPU Units of NJ-series Machine Automation Controllers
• Sysmac Studio Automation Software
• NA-series Programmable Terminals
Special Information
The icons that are used in this Guide are described below.
Additional information to read as required.
This information is provided to increase understanding or make operation easier.
Precautions for Correct Use
Precautions on what to do and what not to do to ensure proper operation and
performance.
To Next Page
Loading...
Need help?
General
