Omron SYSMAC NX series Startup Guide

6
Related Manuals
The following manuals are related to this Guide. Use these manuals for reference.
Manual name
Cat. No.
Model numbers
Application
Description
NX-series Load Cell Input
Unit Startup Guide for
Weight Measurement
(this guide)
P104 NX-RS1201
Learning the startup
procedures for a weight
measuring system using the
NX-series Load Cell Input
Unit
The startup procedures for a weight
measuring system using the
NX-series Load Cell Input Unit are
described.
NX-series Load Cell Input
Unit User’s Manual
W565 NX-RS□□□□ Learning how to use an
NX-series
Load Cell Input Unit
The hardware, setup methods, and
functions of the NX-series Load Cell
Input Unit are described.
NJ/NX-series Sysmac
Library User’s Manual for
Weighing Control Library
W569 SYSMAC-XR010 Learning the function block
specifications in the
Weighing Control Library
Information required to use the
Weighing Control Library is
described.
Sysmac Studio Version 1
Operation Manual
W504 SYSMAC-SE2□□□ Learning about the
operating procedures and
functions of the Sysmac
Studio.
The operating procedures of the
Sysmac Studio are described.
NJ-series CPU Unit
Hardware User’s Manual
W500 NJ501-□□□□
NJ301-□□□□
Learning the basic
specifications of the
NJ-series CPU Units,
including introductory
information, designing,
installation, and
maintenance.
Mainly hardware
information is provided.
An introduction to the entire
NJ-series system is provided along
with the following information on a
Controller built with an NJ501 CPU
Unit.
・Features and system configuration
・Introduction
・Part names and functions
・General specifications
・Installation and wiring
・Maintenance and inspection
Use this manual together with the
NJ-series CPU Unit Software User’s
Manual (Cat. No. W501).
NJ-series CPU Unit
Software User’s Manual
W501 NJ501-□□□□
NJ301-□□□□
Learning how to program
and set up an NJ-series
CPU Unit.
Mainly software information
is provided.
The following information is provided
on a Controller built with an NJ-series
CPU Unit.
・CPU Unit operation
・CPU Unit features
・Initial settings
・Programming based on IEC
61131-3 language specifications
Use this manual together with the
NJ-series CPU Unit Hardware User’s
Manual (Cat. No.W500).

Omron SYSMAC NX series Specifications

General

Brand	Omron
Model	SYSMAC NX series
Category	Controller
Language	English