Omron SYSMAC NX series Startup Guide

13
1.2. Applicable Load Cells
The table below shows the specifications of the NX-RS1201 Load Cell Input Unit used for
explanation in this Guide. Select the applicable load cell within the range of specifications as
shown in the table.
Load cell excitation
voltage
Input range
Connection to load
cell
Number of load cell
input
5 VDC ±10%
Output current: 60mA
or less
-5.0 to +5.0 mV/V 6-wire type or 4-wire
type
1
For use of a load cell for which a load cell excitation voltage of more than 5 VDC is
recommended, ask the load cell’s manufacturer if the use of 5 VDC is acceptable.
*1
You cannot
use a load cell whose load cell excitation voltage is less than 5 VDC in its specifications.
For use of multiple load cells in parallel connection, the total current supplied to the load cell
should be 60 mA or less.
*1. For example, if the load cell excitation voltage is specified as 5 to 10 VDC in the
specifications, its use is possible. If specified as 10 VDC, ask the load cell’s manufacturer if
the use of 5 VDC is acceptable.

Omron SYSMAC NX series Specifications

General

Brand	Omron
Model	SYSMAC NX series
Category	Controller
Language	English