Omron TJ2-MC64 - PROGRAMMING

BASIC commands
PROGRAMMING MANUAL 29
Revision 1.0
3.2.13 $ (Hexadecimal input)
/i
3.2.14 ' (Comment field)
/i
3.2.15 : (Statement separator)
/i
3.2.16 #
/i
Type System command
Syntax $hex_num
Description The $ command makes the number that follows a hexadecimal number.
Arguments • hex_num
A hexadecimal number (consisting of the characters 0 - 9 and A - F).
hex_num ranges from 0 to 1FFFFFFFFFFFFF.
Example >>TABLE(0, $F, $ABCD)
>>print TABLE(0), TABLE(1)
15.0000 43981.0000
See also HEX (PRINT)
Type Program command
Syntax '
Description ' marks all that follows it on a line as comment and not program code. Com-
ment is not executed when the program is run. You can use ' at the beginning
of a line or after a valid statement.
Arguments N/A
Example ' This line is not printed
PRINT "Start"
See also N/A
Type Program command
Syntax :
Description The statement separator : separates multiple BASIC statements on one line.
You can use it on the command line and in programs.
Arguments N/A
Example PRINT "THIS LINE": GET low : PRINT "DOES THREE THINGS"
See also N/A
Type Special character
Syntax #
Description The # symbol is used to specify a communications channel to be used for
serial input/output commands.
Note: Communications Channels greater than 3 will only be used when run-
ning the Trajexia Studio software.
Arguments N/A
Example PRINT #1, "RS232"
PRINT #2, "RS485"
Example IF KEY #1 THEN GET #1, k
Checks keypad on RS232 port, which represent communication channel 1.
See also N/A