Omron V600 Series Operation Manual

3-4SectionCommand Types and Responses
42
Subcommand Format
Header
P W C/E 1/2 FCS
∗
For 1 to 1 procedure
Polling
auto
write
R/W Head no.
Specifies cancel or inquiry of polling auto processing results
C: Processing result inquiry
E: Cancel
R/W Head no.
P W C/E 1/2
∗
@ Unit No.
FCS
For 1 to N procedure
Polling
auto
write
Specifies cancel or inquiry of polling auto processing results
C: Processing result inquiry
E: Cancel
Header
00 to 15
Subcommand Response Format
PW0 0
∗
For 1 to 1 procedure
Header
Polling
auto
write
00: At normal end
74: DC not close (after second pass)
75:
Polling auto processing canceled (before communications
processing with DC)
76:
Polling auto processing canceled (the DC approaches, and
processing is canceled during communications processing
with the DC and after completion of processing)
End code (see page 48)
PW0 0
∗
@ Unit No.
FCS
For 1 to N procedure
Header
Polling
auto
write
00: At normal end
74: DC not close (after second pass)
75:
Polling auto processing canceled (before communications
processing with DC)
76:
Polling auto processing canceled (the DC approaches, and
processing is canceled during communications processing
with the DC and after completion of processing)
End code (see page 48)
00 to 15

Omron V600 Series Specifications

General

Operating Frequency	13.56 MHz
Supported Standards	ISO 15693, ISO 18000-3
Read Range	Up to 70 mm (depending on tag and environment)
Power Supply	24 VDC ±10%
Operating Temperature	-10 to 55°C (with no icing or condensation)
Humidity	35% to 85% (non-condensing)
Communication Interface	RS-232C