Omron V600 Series Operation Manual

4-4SectionData Read and Write Operations
66
4-4-3 Continuous Write (WRITE2)
This is used to write the same one byte of data to a continuous series of DC
addresses.
Operation Procedure The example shows the procedure for writing 0F into locations 50 to 5F.
a
_
dXX
Job specification
Head no. setting
Page no. setting
ARDS
5 0
a
_
dXX
a50dXX
a50dXX
ARDS
a5FdXX
5 F
DATA
0 F
a5Fd
_
WRITE
2
SET
End address display
CWRITE?
CWa5Fd0F
a5Fd0F
Continuous write display
RESET
(Cancel operation by pressing )
(2)
(1)
(3)
(4)
(5)





The continuous write operation writes the job specification head and page num -
bers.
1, 2, 3... 1. Specify the start address.

Omron V600 Series Specifications

General

Operating Frequency	13.56 MHz
Supported Standards	ISO 15693, ISO 18000-3
Read Range	Up to 70 mm (depending on tag and environment)
Power Supply	24 VDC ±10%
Operating Temperature	-10 to 55°C (with no icing or condensation)
Humidity	35% to 85% (non-condensing)
Communication Interface	RS-232C