5-4SectionDIP Switch Settings
84
Note 1. Set
the data length to
7 bits to select the ASCII code and 8 bits to select the
JIS 8-digit code.
2. Set
the parity setting to E to designate the even parity and O to designate the
odd parity. Set the parity setting to N if no parity is designated.
Note It
is extremely important to turn of
f the power to
the ID Controller before making
the DIP switch settings. DIP switch settings are acted upon at power supply
startup, and consequently changing DIP switch settings while the system is in
operation will have no effect.
To Next Page
Loading...
