RFID System
User's Manual
SECTION 6
Handling Errors
SECTION 6
Troubleshooting
73
Bit 0 and bit 4
Flashing red
Error End +
Command
Error
There is an error with the execution
command, or the command cannot not
be received.
Check the command, address, and number of bytes to process.
Bit 7 to bit 0
Flashing red
Error End +
Switch
Error
Mode switch setting error Set the mode switch correctly.
Bit 7 to bit 0
Lit red
Error End +
System
Error
The FL Remote ID cannot operate. If the error continues after resetting the power, replace the FL
Remote ID.
LED Output bit Error Corrective action
To Next Page
Loading...
