62
Section 5
5.1 Accessing setup mode
V700-L21
User's Manual
Section 5
Setup Mode
In setup mode, the operator can define various parameters such as the operating conditions for CIDRW.
5.1 Accessing setup mode
To access the setup mode, the three methods below are available:
(1) Power up the CIDRW controller with its MODE switch in position 3.
(2) In normal operation mode, send a subsystem command (S18F13 Change State CPVAL1="PS") to
the CIDRW controller.
∗ CPVAL1="PS" is an extended function specific to Model V700-L21 controller, and does not conform to
SEMI standards.
(3) Connect the setup mode startup cable to the SECS port, and
then power UP the CIDRW controller in normal operation mode (MODE switch in position 0).
<Setup mode startup cable connection>
• Recommended cable: CO-MA-VV-SB 5PX28AWG (Hitachi Cable, Ltd.)
• Recommended connector: socket-Model XM2D-0901 (OMRON), hood-Model XM2S-0913 (OMRON)
In the setup mode, the STATUS indicators will function as listed below:
: Stably lit, : Unlit, : Flashing
Status OPERATING ALARMS BUSY ERROR
Standby for data reception (idling, with correct setup)
Receiving data
Parameter setup failed
Symbol
Pin No.
Pin No.
Symbol
11
RD 2 2 RD
SD 3 3 SD
44
SG 5 5 SG
66
RS 7 7 RS
CS 8 8 CS
DOS/V
PC
D-SUB
9-pin
female
#4-40
99
CIDRW
controller
D-SUB
9-pin
female
#4-40
To Next Page
Loading...
