44
Section 3 SETUP
ZFV
User’s Manual
Section 3
About Setup
About Setup
Basic Knowledge for Operation
■ Switching Modes
There are 3 operating modes as follows. Switch to the desired mode before you start
operation. To switch the operating mode, use the mode switch.
■ Switching Menus
There are two setup menus in the MENU mode. Switch the menu according to your
specific requirements.
To switch the menu, use the menu selector switch.
Mode Description
MENU mode This mode is for executing teaching or setting up the measurement conditions.
ADJ mode This mode is for setting the judgment threshold values.
RUN mode This mode is for performing actual measurement.
Setup Menu Description
STD menu This is the standard menu.
First, set the measurement conditions in this menu.
EXP menu This is the expert menu.
Switch to this menu to make a more advanced setup.
To Next Page
Loading...
Need help?
General
