82
Section 3 SETUP
ZFV
User’s Manual
Section 3
Saving the Set Measurement Conditions
Saving the Set Measurement Conditions
The set measurement conditions are saved to the amplifier unit when it is switched to RUN
mode.
Saving is done automatically, and no confirmation message is displayed.
If the power is turned off without saving, the changed contents, including the teaching
results, will be cleared from memory.
When external TEACH signal teaching is successful in RUN mode, the set measurement condi-
tions are automatically saved.
When the TEACH key is pressed from the teaching screen to teach, the contents will not be saved
unless the amplifier unit is switched to RUN mode once.
To Next Page
Loading...
