STAND: 17.06.2019 9910_Operation_Manual_STANDCONTROL_C1_Rev1v1_EN Seite 31 von 41
11 Disassembly/Maintenance
11.1 Disassembly
1. Disconnect the controller from the mains.
2. Disconnect all connections between the controller and the accessories.
3. Disassemble the controller from the table.
11.2 Maintenance
Warning: Do not open the controller. Opening the controller will render all warranties
from OMT null and void.
Danger: If the controller is opened, there is a danger of an electric shock. This danger
continues to exist even for a few minutes after disconnection from the mains supply.
Danger: If you find defective cables, immediately isolate the controller from the mains.
Pull the mains plug.
Check the plug-and-connector joints at the controller regularly for firm fitting. Check all the cables
regularly for defects. If you find defective cables, plugs or loose plug-and-connector joints, replace the
cables. If that is not possible, or does not bring about any improvement, contact OMT customer
service.
11.3 Cleaning and maintenance
Warning: Aggressive cleaning agents can cause damage or discolouration
on the product. Therefore, only agents with a pH value of 6-8 may be used.
The STAND.CONTROL C1 can be wiped from the outside with a soft cloth. Coarse soiling may only
be removed with a soft, damp cloth. Ensure that no moisture penetrates into the housing.
To Next Page
Loading...