OMT STAND.CONTROL C1 - 2 Explanation of Terms and Index of Abbreviations

STAND: 17.06.2019 9910_Operation_Manual_STANDCONTROL_C1_Rev1v1_EN Seite 5 von 41
2 Explanation of terms and index of abbreviations
Abb./Term
Meaning
OMT
Oelschläger Metalltechnik GmbH
Controller
Table controller STAND.CONTROL C1
Reset position
Lowermost mechanical end position of the table
Minimal position
Lowermost software end position of the table
Safety stop
Stop position from which onwards a safety zone up to the minimal position starts