To Next Page

To Previous Page

STAND: 17.06.2019 9910_Operation_Manual_STANDCONTROL_C1_Rev1v1_EN Seite 4 von 41

1 Preface

Dear Customer:

We are pleased that you have decided to purchase our product. This operating manual explains how

this table controller is to be installed, used and maintained. All the table controllers are put through a

function test and quality inspection before they leave our factory. Should you nonetheless have prob-

lems with your table controller, you can contact our service department at any time.

It is essential that the table control unit is installed in accordance with these instructions. Changes to

the table frame, table control or accessories and improper use can have a negative effect on safety,

function and service life.

This operating manual has been written for the table controller STAND.CONTROL C1.

Oelschläger Metalltechnik GmbH

Questions and Answers:

Need help?

Do you have a question about the OMT STAND.CONTROL C1 and is the answer not in the manual?

OMT STAND.CONTROL C1 Specifications

General