OMT STAND.CONTROL C1 User Manual

STAND: 17.06.2019 9910_Operation_Manual_STANDCONTROL_C1_Rev1v1_EN Seite 36 von 41
Display Description Remedy
Discrepancy in the parameters
The parameters in one controller do
not match the number of legs or the
parameters are not the same in the
two controllers.
Contact Customer Service and have
the parameter set of the table
checked.
Reference movement required or
Initialisation movement is carried out.
Carry out a reference movement.
System protection / system pause
The powering-on duration of the sys-
tem was exceeded.
Wait until the controller has cooled
and the display turns off. Then,
the movement duration of 17 seconds
is cleared. Only after 18 min does the
table move again for a full 2 min.
ATTENTION! The calculation of the
powering-on duration is performed
even if there is no mains voltage
present.
Collision detected Remove the hindrance.
The table moves; height display

OMT STAND.CONTROL C1 Specifications

General

Brand	OMT
Model	STAND.CONTROL C1
Category	Controller
Language	English