FEB-4720 Main Board
CD-ROM Installation
1. Please make sure the IDE2 in the CMOS setup are
enabled.
2. Turn off the power.
3. Plug CD-ROM cable to CD-ROM port.
Note: If the CD-ROM cannot be detected by the system, please
refer to
troubleshooting.
Cash Drawer Installation
1. Before the cash drawer has been connected to Model H800, please make sure the drive
voltage and cable pin assignment of the cash drawer is matched to the definition of the cash
drawer port of Model H800. Please refer to page 54
Cash drawer RJ11 connector.
2. Plug cash drawer cable into cash drawer port.
Note: If the cash drawer cannot be detected by the system, please refer to troubleshooting.
20
To Next Page
Loading...
Need help?
General