Use of the Power Tool:
Caution: Do not alter or misuse the tool. Any alteration or modication is a misuse
and may result in serious personal injury.
Caution: Disconnect the plug from the power source before you make any adjust-
ments, change accessories, or store the tool. Such preventative safety measures re-
duce the risk of starting the power tool accidentally.
Caution: Store idle power tools out of the reach of children and do not allow persons
unfamiliar with the laser tool or these instructions to operate the power tool. Power
tools are dangerous in the hands of untrained users.
NOTICE: Use the power tools, accessories etc. in accordance with these instructions, taking
into account the working conditions and the work to be performed. Use of the power tool for
operations dierent from those intended could result in a hazardous situation with high proba-
bility of supercial injury.
NOTICE: Do not reach into the area of the rotating insertion tools. The proximity of the rotat-
ing tools to your hand may not always be obvious.
NOTICE: Never use dull or damaged insertion tools. Sharp bits must be handled with care.
Damaged bits can snap during use. Dull bits require more force to cut the tool, possibly causing
the bit to break.
NOTICE: The speed and feed of the bit when carving, routing or cutting is very important. Al-
ways observe the recommended speed and feed for the particular bit.
Caution: If the workpiece or bit becomes jammed or bogged down, turn the power
tool "OFF" by the switch. Wait for all moving parts to stop and unplug the tool, then
free the jammed material. If the switch to the tool is left "ON", the tool could restart
unexpectedly causing serious personal injury.
NOTICE: Do not leave a running tool unattended, turn power o. Only when tool comes to a
complete stop and is disconnected from the mains it is safe.
Caution: Do not touch the bit or collet after use. After usage bit and collet are too hot
to be touched with bare hands.
NOTICE: Do not allow familiarity gained from frequent use become commonplace. Always re-
member that a careless fraction of a second is sucient to inict severe injury.
Caution: When using the end mills, V-bits or cutters, always have the workpiece se-
curely clamped. Never attempt to hold the workpiece with your hands while using any
accessories. These tools can jam easily in the material, and can kickback, causing loss
of control resulting in serious injury.
Safety Rules
To Next Page
Loading...