Emergency Stop Switch :
The emergency stop is located on the top of the Controller housing. In order to be able to inter-
vene at all times, the emergency stop has to be positioned in a suitable place. The controller
must be located so it can be reached from any possible operator position.
By pressing the emergency stop switch, the emergency stop is triggered. The control is inter-
rupted. Additionally, the control software receives the signal to stop the operating process. The
machine stops immediately.
ATTENTION! The emergency stop switch can only eect the stop of all components if these
components are electronically connected with the emergency stop switch.
If you want to use a system-guided tool, such as a milling and drilling motor, that features a sep-
arate ON / OFF switch and that is NOT controlled via the PC, you have to make sure that it is ex-
pertly connected with the emergency stop switch. If you do not comply with these require-
ments, the system-guided tool will continue to run although you have activated the emergency
stop switch leading to a high risk of personal injury and damage to property! If you have any
questions, please do not hesitate to contact us!
Residual Risk:
Despite all safety precautions against the contact with rotating or hot tools and the protection
from crushes, a residual risk remains due to a careless handling and automatic movements of
the CNC system.
Safety Rules
To Next Page
Loading...