Oneida Air Systems Supercell

To Next Page

To Previous Page

FIG. 19a

FIG. 19b

FIG. 19c

G17

G16

Closed

Open

oneida-air.com 21

Install the Barrel Gasket (G2) onto the

rounded, bottom edge of the Motor Assembly

(A). e Barrel Gasket (G2) should be oriented

so that the "ribbed" side is facing downwards

[FIG. 18].

Assembly Instructions (Continued)

Using pliers, squeeze and open the Double

Spring Clamp (G17) and slip it onto the

shorter end of the Tubing Assembly (G16A).

en, with the clamp still open, slide the Tube

Assembly (G16) onto the vent tube near the

Cyclone’s (E) inlet, closing the Spring Clamp

once the hose is fully seated [FIG. 19a].

Note: If you are not using the automatic bag

holding feature of the system, the Switch Valve

(G16B) of the Tube Assembly MUST be in the

closed position [FIG 19b]. Otherwise leave the

Tube Assembly in the open position [FIG 19c].

FIG. 18



DO NOT TURN ON OR PLUG IN YOUR DUST COLLECTOR UNTIL INSTALLATION IS COMPLETED.

NEVER RUN THE SYSTEM WITHOUT THE MOTOR COWLING IN PLACE.

Oneida Air Systems Supercell - Page 23