Onicon FT-3500 - Page 65

ON I CON
Flow and Energy Measurement
ONICON Incorporated • 11451 Belcher Road South • Largo, FL 33773 • USA
(P) 727.447.6140 • sales@onicon.com • onicon.com
ALERT POTENTIAL ISSUE POSSIBLE SOLUTION
“Warn Flow Sample Overrun 1” Meter internal error - performance may be
impacted
Contact ONICON. RMA needed
“Warn Coil BIT Samp Overrun 1” Meter internal error - performance may be
impacted
Contact ONICON. RMA needed
“Warn Flow Sample Overrun 2” Meter internal error - performance may be
impacted
Contact ONICON. RMA needed
“Warn Coil BIT Samp Overrun 2” Meter internal error - performance may be
impacted
Contact ONICON. RMA needed
“Warn Flow Sample Trans Error” Meter internal error - performance may be
impacted
Contact ONICON. RMA needed
“Warn Coil BIT Samp Trans Error” Meter internal error - performance may be
impacted
Contact ONICON. RMA needed
“Warn Flow Sample Near Full” Meter internal error - performance may be
impacted
Contact ONICON. RMA needed
“Warn Coil BIT Samp Near Full” Meter internal error - performance may be
impacted
Contact ONICON. RMA needed
“Warn UART Tx Error” Meter internal error - performance may be
impacted
Contact ONICON. RMA needed
“Warn UART Rx Error” Meter internal error - performance may be
impacted
Contact ONICON. RMA needed
“Warn UART Tx Hang” Meter internal error - performance may be
impacted
Contact ONICON. RMA needed
“Warn Meter Temp” Meter internal CPU temperature outside
operating limits: 34 F to 185 F
Verify meter operating environment temperature is
within listed specication (-20°F to 150°F). If problem
persists contact ONICON support.
“Warn Comm Board Compat Error” Comm Board message protocol error Update rmware on both the main board and
communication board. Contact ONICON for an update
procedure or visit our website for an Update Procedure
TechNote.
“Warn SPI/I2C Transient Error” Transient error detected on meter internal
communication bus
Contact ONICON. RMA needed