Onkyo NR3007 - TX AV Network Receiver User Manual

135
Multi Zone—Continued
Note:
This procedure can also be performed on the AV receiver
by using its [SETUP] button, arrow buttons, and
[ENTER] button.
■ Zone2/3 Out
If you’ve connected your Zone 2/3 speakers to an amp
with no volume control, set the “Zone2 Out” and “Zone3
Out” setting, respectively, to “Variable” so that you can
set the volume, balance, and tone of zone 2/3 on the AV
receiver.
■ Zone2/3 Maximum Volume
With this setting, you can limit the maximum volume for
Zone 2/3. When the “Volume Display” setting is set to
“Absolute”, the “Maximum Volume” range is 50 to 99.
When it’s set to “Relative”, the range is –32 dB to
+17 dB. To disable this setting, select “Off”.
■ Zone2/3 Power On Volume
This setting determines what the volume will be for
Zone 2/3 each time the AV receiver is turned on.
When the “Volume Display” preference is set to “Abso-
lute”, the range is “Last”, “Min”, 1 to 99, or “Max”.
When it’s set to “Relative”, the range is “Last”, –Q dB,
–81 dB to +18 dB.
To use the same volume level as when the AV receiver
was last turned off, select “Last”.
The “Zone2/3 Power On Volume” cannot be set higher
than the “Zone2/3 Maximum Volume” setting.
Setting the Multi Zone
1
Press the [RECEIVER] button
followed by the [SETUP] button.
The main menu appears onscreen.
If the main menu doesn’t appear, make
sure the appropriate external input is
selected on your TV.
2
Use the Up and Down [q]/[w]
buttons to select “7. Hardware
Setup”, and then press [ENTER].
The “Hardware Setup” menu appears.
3
Use the Up and Down [q]/[w]
buttons to select “2. Multi Zone”,
and then press [ENTER].
The “Multi Zone” menu appears.
4
Use the Up and Down [q]/[w]
buttons to select an item, and
use the Left and Right [e]/[r]
buttons to change it.
The items are explained below.
7. Hardware Setup
1. Remote ID
2. Multi Zone
3. Tuner
4. HDMI
5. Network
6. Firmware Update
Zone2 Out
Zone2 Maximum Volume
Zone2 Power On Volume
Zone3 Out
Zone3 Maximum Volume
Zone3 Power On Volume
Fixed
Off
Last
Fixed
Off
Last
7–2. Multi Zone
5
When you’ve finished, press the
[SETUP] button.
The setup menu closes.
Fixed: The Zone 2/3 volume must be set on the
amp in that zone (default).
Variable: The Zone 2/3 volume can be set on the AV
receiver.

Onkyo NR3007 - TX AV Network Receiver Specifications

General

Brand	Onkyo
Model	NR3007 - TX AV Network Receiver
Category	Receiver
Language	English