25
Connecting the AV receiver—Continued
The FRONT WIDE/ZONE 2 L/R and SURR
BACK/ZONE 3 L/R terminal posts can be used with
front wide speakers and surround back speakers respec-
tively, or bi-amped to provide separate tweeter and
woofer feeds for a pair of front speakers B that support
bi-amping, providing improved bass and treble perfor-
mance.
• When bi-amping is used, surround back speakers can-
not be used.
• For bi-amping, the FRONT WIDE/ZONE 2 L/R ter-
minal posts connect to the front speakers’ woofer ter-
minals. And the SURR BACK/ZONE 3 L/R terminal
posts connect to the front speakers’ tweeter terminals.
• Once you’ve completed the bi-amping connections
shown below and turned on the AV receiver, you must
set the “Speakers Type(FrontB)” setting to “Bi-Amp”
to enable biamping (see page 57).
• When front Speakers B are biamped, front Speakers A
must be wired normally.
Important:
• When making the bi-amping connections, be sure
to remove the jumper bars that link the Speaker’s
tweeter (high) and woofer (low) terminals.
• Bi-amping can only be used with speakers that support
bi-amping. Refer to your speaker manual.
Bi-amping Speaker Hookup
Bi-amping the Front Speakers B
1
Connect the AV receiver’s FRONT
WIDE/ZONE 2 R positive (+) terminal to the
right speaker’s positive (+) Woofer (low) termi-
nal. And connect the AV receiver’s FRONT
WIDE/ZONE 2 R negative (–) terminal to the
right speaker’s negative (–) Woofer (low) termi-
nal.
2
Connect the AV receiver’s SURR BACK/ZONE 3
R positive (+) terminal to the right speaker’s pos-
itive (+) Tweeter (high) terminal. And connect the
AV receiver’s SURR BACK/ZONE 3 R negative
(–) terminal to the right speaker’s negative (–)
Tweeter (high) terminal.
3
Connect the AV receiver’s FRONT
WIDE/ZONE 2 L positive (+) terminal to the left
speaker’s positive (+) Woofer (low) terminal. And
connect the AV receiver’s FRONT
WIDE/ZONE 2 L negative (–) terminal to the left
speaker’s negative (–) Woofer (low) terminal.
4
Connect the AV receiver’s SURR BACK/ZONE 3
L positive (+) terminal to the left speaker’s posi-
tive (+) Tweeter (high) terminal. And connect the
AV receiver’s SURR BACK/ZONE 3 L negative
(–) terminal to the left speaker’s negative (–)
Tweeter (high) terminal.
Woofer (low)
Tweeter (high)
Tweeter (high)
Woofer (low)
Left speaker
Right speaker
To Next Page
Loading...
