136
Multi Zone—Continued
This section explains how to turn Zone 2/3 on and off,
how to select an input source for Zone 2/3, and how to
adjust the volume for Zone 2/3.
Controlling Zone 2/3 from the AV receiver
Note:
When Zone 2/3 is turned off, the output from the 12V
TRIGGER OUT ZONE 2/3 goes low (0 volts).
Controlling Zone 2/3 with the Remote
Controller
Note:
To control Zone 2/3, you must press the remote control-
ler’s [ZONE] button first.
The ZONE button turns red while Zone 2 is on, and
green while Zone 3 is on.
Using Zone 2/3
1
To turn on Zone 2/3 and select an
input source, press the [ZONE 2]
or [ZONE 3] button followed by
an input selector button within 8
seconds.
Zone 2/3 turns on, the ZONE 2/3 indi-
cator lights up.
Tip:
The 12V TRIGGER OUT ZONE 2/3
goes high (+12 V).
To select AM or FM press the
[TUNER] input selector and the
[ZONE 2] or [ZONE 3] button repeat-
edly. You can also select SIRIUS
(North American models).
To select the same source as that of the
main room, press the [ZONE 2] or
[ZONE 3] button twice. “Zone 2 Selec-
tor: Source” or “Zone 3 Selector:
Source” appears on the display.
2
To turn off Zone 2/3, press the
[ZONE 2] or [ZONE 3] button.
The ZONE 2 or ZONE 3 indicator
flashes.
Press the [OFF] button.
The zone is turned off, and the ZONE 2
or ZONE 3 indicator goes off.
ZONE 3
ZONE 2
OFF
ZONE 2 indicator
ZONE 3 indicator
Input selector buttons
1
Press the [ZONE] button
repeatedly, then point the remote
controller at the AV receiver and
press the [ON] button.
Tip:
The 12V TRIGGER OUT ZONE 2/3
goes high (+12 V).
2
To select an input source for
Zone 2/3, press the [ZONE]
button repeatedly, followed by an
INPUT SELECTOR button.
To select AM or FM press the
[TUNER]
INPUT SELECTOR
and the
[ZONE] button repeatedly. You can
also select SIRIUS (North American
models).
3
To turn off Zone 2/3, press the
[ZONE] button repeatedly,
followed by the [STANDBY]
button.
INPUT
SELECTOR
ON
ZONE
STANDBY
To Next Page
Loading...
