64
Basic Operations
Selecting the Input Source
3
1
3
1
1
1
Use the AV controller’s input selector buttons to select an input source.
To select an input source with the remote controller, press its
[RECEIVER] REMOTE MODE button, and then use its INPUT SELECTOR
buttons.
2
Start playback on the source component.
When you select DVD or another video component, on your TV, you’ll need to select
the video input that’s connected to the AV controller’s COMPONENT VIDEO MON-
ITOR OUT 1 or COMPONENT VIDEO MONITOR OUT 2/ZONE 2 OUT, HDMI
OUT MAIN, HDMI OUT SUB, or MONITOR OUT.
On some DVD players, you may need to turn on the digital audio output.
3
To adjust the volume, use the MASTER VOLUME control, or the remote
controller’s VOL [q]/[w] button.
The volume can be set to
−∞ dB, −81.5 dB through +18.0 dB (relative display).
The AV controller is designed for home theater enjoyment. It has a wide volume range,
allowing precise adjustment.
The volume level can also be displayed as an absolute value. See “Volume Setup” on
page 108.
4
Select a listening mode and enjoy!
See “Using the Listening Modes” on page 75.
To Next Page
Loading...
Need help?
General
