91
Advanced Setup—Continued
Low-Pass Filter for the LFE Channel
With this setting, you can specify the cutoff frequency of
the LFE channel’s low-pass filter (LPF), which can be
used to filter out unwanted hum. The LPF only applies to
sources that use the LFE channel.
*If you’re using THX-certified speakers, select
“80Hz(THX)”.
Double Bass
With this setting, you can boost bass output by feeding
front left and right channel bass sounds to the subwoofer.
This setting can only be made if the “Subwoofer” setting
in step 4 is set to “Yes”, and the “Front” setting in step 5
is set to “Full Band”.
*
If you’re using THX-certified speakers, select
“Off(THX)”.
Note:
This procedure can also be performed on the AV control-
ler by using its [SETUP] button, arrow buttons, and
[ENTER] button.
11
Use the Up and Down [q]/[w] but-
tons to select “LPF of LFE”, and
then use the Left and Right
[e]/[r] buttons to select a low-
pass filter frequency.
The following low-pass filter frequen-
cies can be selected: “80Hz(THX)”,
“90Hz”, “100Hz”, “110Hz”, or
“120Hz”.
Continue with step 12 in the next col-
umn.
This setting is not set automatically by the Automatic
Speaker Setup function (see page 58).
12
Use the Up and Down [q]/[w] but-
tons to select “DoubleBass”, and
then use the Left and Right
[e]/[r] buttons to select:
Off(THX):
The subwoofer only outputs the
LFE channel.
On:
In addition to LFE channel sounds,
the subwoofer outputs front left and
right channel bass sounds.
13
Press the [SETUP] button.
Setup closes.
This setting is not set automatically by the Automatic
Speaker Setup function (see page 58).
To Next Page
Loading...
Need help?
General
