93
Advanced Setup—Continued
Note:
This procedure can also be performed on the AV control-
ler by using its [SETUP] button, arrow buttons, and
[ENTER] button.
Speaker Level Calibration
With the “Level Calibration” settings, you can adjust the
level of each speaker while listening to the test tone so
that the volume of each speaker is the same at the listen-
ing position.
Notes:
• The speakers cannot be calibrated while the output of
the AV controller is muted.
• The test tone is output at the standard level for THX,
which is 0 dB (absolute volume setting 82). If you nor-
mally listen at volume settings below this, be careful
because the test tone will be much louder.
7
Use the Up and Down [q]/[w] but-
tons to select a speaker, and use
the Left and Right [e]/[r] but-
tons to specify the distance.
Specify the distance from the speaker
to your listening position.
Notes:
• The “Center” distance cannot be set
if the “Center” is set to “None”
(page 89).
• The “SurrRight” and “SurrLeft” dis-
tances cannot be set if the “Sur-
round” is set to “None” (page 89).
• The “SurrBack R” and “SurrBack L”
distances cannot be set if “Speaker
Type” is set to “Bi-Amp” (page 55),
“SurrBack” is set to “None”
(page 89).
• The “Subwoofer” distance cannot be
set if “Subwoofer” is set to “No”
(page 90).
8
Repeat step 7 for each speaker.
9
Press the [SETUP] button.
Setup closes.
1
Press the [RECEIVER] REMOTE
MODE button.
2
Press the [SETUP] button.
The main menu appears onscreen.
These settings are set automatically by the Automatic
Speaker Setup function (see page 58).
2, 7
1
3-6
To Next Page
Loading...
Need help?
General
