Onkyo TX-RZ70 - Page 111

111
Playback
Selecting a source to play in ZONE 3
1. While pressing the ZONE 3 HOLD button on the remote controller, press the
input selector of the input you want to play in the separate room.
To control on the main unit, press the ZONE 3 button on the main unit and
then within 8 seconds press the input selector button of the input you want to
play in the separate room.
2
1
Adjusting the volume in ZONE 3
When ZONE 3 speakers are used
1. While pressing the ZONE 3 HOLD button on the remote controller, adjust with
the volume buttons. To control on the main unit, press the ZONE 3 button on
the main unit and then within 8 seconds adjust with the MASTER VOLUME
dial.
1
2
When using an Integrated amplier in the separate room
1. Use the volume dial on the integrated amplier to adjust the volume.
When using an integrated amplier that does not have a volume control,
adjust using the same procedure described in "When ZONE 3 speakers are
used".
• When connecting an integrated amplier that does not have a volume
control, in the Setup menu, set "Multi Zone" - "Zone 3" - "Output Level"
( →p158) to "Variable". If you do not set this, the volume output will be
very loud and there is a danger of damage to the integrated amplier,
speakers, etc.