Onkyo TX-RZ70 - Page 155

155
SetupSetup
5. Hardware
 Network Standby (Default Value: On)
When this function is set to "On", the network function works even in standby
state, and you can turn on the power of the unit via network using an
application such as Onkyo Controller that can control this unit.
• When this function is set to "On", the power consumption in standby state
increases, however, the increase in power consumption is minimized
by automatically entering the HYBRID STANDBY mode where only the
essential circuits operate. Note that even if this function is set to "O󰀨", when
any of the HDMI CEC ( →p147), HDMI Standby Through ( →p147),
USB Power Out at Standby ( →p154) and Bluetooth Wakeup ( →p155)
functions is enabled, this function will be in "On" state regardless of the
setting.
• When connection to the network is lost, "Network Standby" may be disabled
to reduce power consumption. In such a case, turn the unit on by using the
power button on the remote controller or main unit.
 Bluetooth Wakeup (Default Value: O󰀨)
This function wakes up the unit on standby by connecting a BLUETOOTH
enabled device. This is e󰀨ective when "Bluetooth" - "Bluetooth Receiver" is set
to "On".
On When this function is used
• When this function is set to "On", the power consumption
in standby state increases, however, the increase in power
consumption is minimized by automatically entering the
HYBRID STANDBY mode where only the essential circuits
operate.
O󰀨 When this function is not used
• This setting is xed to "O󰀨" if "Bluetooth" - "Bluetooth
Receiver" is set to "O󰀨".
• This setting is also xed to "O󰀨" if "Bluetooth" - "Bluetooth
Receiver" - "Auto Input Change" is set to "O󰀨".
• Wait for a while if "Network Standby" and "Bluetooth Wakeup" cannot be
selected. It can be selected when the network function is activated.