Onkyo TX-SR3100

64
Setup
3. Audio Adjust
 3. DTS
Change the setting of when DTS signals are input.
 DTS Auto Surround (Default Value: On)
When inputting DTS signals that include extended channel information, the
optimum listening mode is automatically selected according to the extended
information contained in the input signal and the speaker conguration of this
unit when playing in the straight decoding listening mode.
On When this function is used
O󰀨 Audio is played using the same amount of channels in the
input signal according to the speaker conguration of this unit.
 Dialog Control (Default Value: 0 dB)
You can increase the volume of dialog portion of the audio up to 6 dB by 1 dB
step so that you can hear the dialog easily in noisy atmosphere.
• This cannot be set for content other than DTS:X.
• Depending on the content, this function may not be selected.
 4. LFE Level
Set the low-frequency e󰀨ect (LFE) level for Dolby Digital series, DTS series,
Multichannel PCM, and DSD signals.
 LFE Level (Default Value: 0 dB)
Select the low-frequency e󰀨ect (LFE) level of each signal from "0 dB" to
"-∞ dB". If the low-frequency e󰀨ect sound is too strong, select "-20 dB" or
"-∞ dB".
 5. Volume
Change the Volume settings.
 Volume Display (Default Value: Absolute)
Switch the volume display between the absolute value and relative value. The
absolute value 82.0 is equivalent to the relative value 0.0 dB.
Absolute Absolute value such as "0.5" and "99.5"
• If the absolute value is set to 82.0, "82.0 Ref" will appear on
the display.
Relative Relative value such as "-81.0 dB" and "+18.0 dB"
 Mute Level (Default Value: -∞ dB)
Set the volume lowered from the listening volume when muting is on. Select a
value from "-∞ dB", "-40 dB", and "-20 dB".
 Maximum Volume (Default Value: O󰀨)
Set the maximum value to prevent the volume from becoming too loud.
Select a value from "O󰀨", and "50" to "99". (When "Volume Display" is set to
"Absolute")
 Power On Volume (Default Value: Last)
Set the volume level of when the power is turned on. Select a value from "Last"
(Volume level before entering standby mode), "Min", "0.5" to "99.5" and "Max".
(When "Volume Display" is set to "Absolute")
• You cannot set a higher value than that of "Maximum Volume".
 Headphone Level (Default Value: 0.0 dB)
Adjust the output level of headphones. Select a value between "-12.0 dB" and
"+12.0 dB".