Onkyo TX-SR3100

100
Appendix
General Specications
Amplier Section North American and Taiwanese models
European, Middle East, Australian and Asian
models
Rated Output Power
(North American models)
With 8 ohm loads, both channels driven, from 20 Hz-
20 kHz; rated 80 watts per channel minimum RMS
power, with no more than 0.08% total harmonic
distortion from 250 milliwatts to rated output. (FTC)
(Taiwanese models)
5 ch × 135 W at 6 ohms, 1 kHz, 1 ch driven of 1% THD (IEC)
5 ch × 135 W at 6 ohms, 1 kHz, 1 ch driven of 1% THD
(IEC)
Maximum E󰀨ective Output Power
(North American models)
155 W at 6 ohms, 1 kHz, 1 ch driven of 10% THD
(Taiwanese models)
5 ch × 155 W at 6 ohms, 1 kHz, 1 ch driven of 10% THD
(JEITA)
(European models)
5 ch × 155 W at 6 ohms, 1 kHz, 1 ch driven of 10% THD
(IEC)
(Middle East, Australian and Asian models)
5 ch × 155 W at 6 ohms, 1 kHz, 1 ch driven of 10% THD
(JEITA)
THD+N (Total Harmonic Distortion + Noise) 0.08% (20 Hz - 20,000 Hz, Rated output power)
Input Sensitivity and Impedance 200 mV/32 kΩ (LINE(RCA))
Rated RCA Output Level and Impedance
PRE OUT (SUBWOOFER) : 1 V/470 Ω
LINE OUT (ZONE B) : 1 V/200 mV/2.3 kΩ
Frequency Response 10 Hz - 100 kHz/+1 dB, –3 dB (Direct)
Tone Control Characteristics ±10 dB, 20 Hz (Bass), ±10 dB, 20 kHz (Treble)
Signal to Noise Ratio 106 dB (IHF-A, LINE IN, SP OUT)
Supported impedance of Speakers 4 Ω - 16 Ω
Headphone Rated Output 80 mW + 80 mW (32 Ω, 1 kHz, 10% THD)
Supported impedance of Headphones 8 Ω - 600 Ω
Headphones Frequency Response 10 Hz - 100 kHz