Onkyo TX-SR606 - Page 86

86
Zone 2 —Continued
Note:
•To control Zone 2, you must press the remote control-
ler’s [ZONE 2] button first.
Adjusting the Volume of Zones
Muting Zones
On the remote controller, press
the [ZONE 2] REMOTE MODE
button, and then use the VOL
[ ]/[ ] button.
On the AV receiver, use the ZONE
2 LEVEL [ ]/[ ] buttons.
If your Zone 2 speakers are connected
to an amp in Zone 2, use its volume
control to adjust the volume.
On the remote controller, press
the [ZONE 2] REMOTE MODE
button, and then press the [MUT-
ING] button.
To unmute a zone, on the remote
controller, press the [ZONE 2]
REMOTE MODE button, and then
press the [MUTING] button again.
Remote
controller
AV receiver/
TX-SR606En.book Page 86 Friday, May 9, 2008 1:28 PM