Onkyo TX-SR606 - Zone 2 Operations-Continued

85
Zone 2 —Continued
This section explains how to turn Zone 2 on and off, how
to select an input source for Zone 2, and how to adjust
the volume for Zone 2.
Controlling Zone 2 from the AV receiver
Notes:
• Only analog input sources are output by Zone 2. Dig-
ital input sources are not output. If no sound is heard
when an input source is selected, check to make sure
it’s connected to an analog input.
• While Zone 2 is on, the Auto Power On/Standby and
Direct Change functions do not work.
• While Powered Zone 2 is being used, listening modes
that require surround back speakers (6.1/7.1), such as
Dolby Digital EX and DTS-ES are unavailable.
Controlling Zone 2 with the Remote
Controller
Using Zone 2
1
To turn on Zone 2 and select an
input source, press the [ZONE 2]
button repeatedly.
Alternatively, press the [ZONE 2]
button followed by an input
selector button within 8 seconds.
Zone 2 turns on and ZONE 2 indicator
lights up.
To select the same source as that of the
main room, press the [ZONE 2] button
repeatedly until “Z2 Sel: Source”
appears.
To select AM or FM press the [TUNER]
input selector button repeatedly. On the
North American model, you can also
select SIRIUS.
Note:
•You cannot select different AM or
FM radio stations for your main
room, Zone 2. The same AM/FM
radio station will be heard in each
room.
2
To turn off Zone 2, press the
ZONE 2 [OFF] button.
ON/STANDBY
ZONE 2
ZONE 2 LEVEL
TONE
MOVIE/TV MUSIC GAME DISPLAY RT/PTY/TP MEMORY
CLEAR
DIGITAL INPUT TUNING MODE OFF
PHONES
MULTI CH DVD VCR/DVR CBL/SAT GAME/TV AUX TAPE TUNER CD
SETUP
SETUP MIC VIDEO
L AUDIO R
AUX INPUT
ENTER RETURN
TUNING PRESET
MASTER VOLUME
AV RE CEIVER TX-SR606
STANDBY
ZONE 2
PURE AUDIO
ZONE 2
OFF
ZONE 2
OFF
1
Press the [ZONE 2] button, then
point the remote controller at the
AV receiver and press the
[ON/STANDBY] button.
Zone 2 turns on and ZONE 2 indicator
lights up.
2
To select an input source for
Zone 2, press the [ZONE 2] but-
ton, followed by an INPUT
SELECTOR button.
To select AM or FM press the
[TUNER] INPUT SELECTOR button
repeatedly. On the North American
model, you can also select SIRIUS.
Note:
•You cannot select different AM or
FM radio stations for your main
room, Zone 2. The same AM/FM
radio station will be heard in each
room.
3
To turn off Zone 2, press the
[ZONE 2] button, followed by the
[ON/STANDBY] button.
ZONE2
ON/STANDBY
INPUT
SELECTOR
TX-SR606En.book Page 85 Friday, May 9, 2008 1:28 PM