Onkyo TX-SR607 - Page 88

88
Zone 2—Continued
Controlling Zone 2 with the Remote
Controller
Note:
To control Zone 2, you must press the remote control-
ler’s [ZONE 2] button first.
Adjusting the Volume for Zone 2
Muting Zones
Notes:
• Only analog input sources are output by the ZONE 2
LINE OUT and ZONE 2 L/R speaker terminals. Dig-
ital input sources are not output. If no sound is heard
when an input source is selected, check if it’s con-
nected to an analog input.
• While Powered Zone 2 is being used, listening modes
that need surround back speakers (i.e., Dolby Digital
EX and DTS-ES) are unavailable.
• While Zone 2 is on, u functions will not work.
• You cannot select different AM or FM radio stations
for your main room and Zone 2. The same AM/FM
radio station will be heard in each room. For example,
if you have an FM station for the main room, that sta-
tion will also be used in Zone 2.
• Zones can also be unmuted by adjusting the volume.
1
Press the [ZONE 2] button, then
point the remote controller at the
AV receiver and press the [ON/
STANDBY] button.
Zone 2 turns on, the ZONE 2 indicator
lights up.
2
To select an input source for
Zone 2, press the [ZONE 2]
button, followed by an INPUT
SELECTOR button.
To select AM or FM press the [TUNER]
INPUT SELECTOR button repeatedly.
On the North American model, you can
also select SIRIUS.
Note:
You cannot select different AM or FM
radio stations for your main room and
Zone 2. The same AM/FM radio station
will be heard in each room.
3
To turn off Zone 2, press the
[ZONE 2] button, followed by the
[ON/STANDBY] button.
INPUT
SELECTOR
ON/
STANDBY
ZONE2
Remote
controller
On the remote controller, press
the [ZONE 2] button, and then
use the VOL [q]/[w] button.
AV receiver
On the AV receiver, press the
[ZONE 2] button (the ZONE 2
indicator and Zone 2 selector on
the display flashes) and then use
the [–]/[+] buttons within 8
seconds.
If your Zone 2 speakers are connected
to a receiver or integrated amp in Zone
2, use its volume control to adjust the
volume.
Remote
controller
On the remote controller, press
the [ZONE 2] button, and then
press the [MUTING] button.
To unmute a zone, on the remote
controller, press the [ZONE 2]
button, and then press the
[MUTING] button again.