Onkyo TX-SR701 - Navigating Setup Menus; Using the remote controller for setup; Buttons used for navigating menus

Configuring the speakers
Using the remote controller
1. Press the TEST button.
You will hear a pink noise which will be
emitted from the front left speaker.
(1) Remember the volume level of this noise and then press the CH
SEL button. The TX-SR601/601E will now emit the pink noise
from the center speaker.
(2) Using the LEVEL •/V buttons, ac[just the volume level of the
noise from the center speaker so thai it is a/the same level as
thai was emitted from the front left speaker.
(3) Press the CH SEL button again. The TX-SR601/601E will now
emit the pink noise from the front right speaker.
Use the LEVEL •/V buttons to at/just the volume of the noise
from the front right speaker so that it is the same level as that
was emitted from the cenler speaker.
(4) Use the CH SEL button to select other speakers and ac[just the
volumes until all speakers are adjusted to the same level.
'Ihe pink noise level can be adjusted to anywhere between 12 and
+12 decibels for all speakers in 1-decibel increments, l_k)r
subwoofer, values between 15 and +12 dB can be set.
2. Press the TEST button to complete
the procedure.
Buttons used for navigating through the menus
You can change settings in the Setup Menu using the buttons on the
front panel and on the remote controller.
The buttons on the remote controller correspond to those on the TX-
SRT01/701 E/601/601E as shown below.
Buttons on TX-SR701/701E/
Buttons on remote controller
601/601E
Displaying the Main Menu and exiting the menu
_) SETUP _l, SETUP
Selecting a menu or menu item
(upper edge of UP
ENTER button)
(lower edge of DOWN
ENTER button)
T
Setting the value
(left edge of LEFT
ENTER button)
(right edge of RIGHT
ENTER button)
Selecting the menu
ENTER _r_ ENTER
Returning to the previous screen
RETURN RETURN
36