Onkyo TX-SR701 - Macro Function Management; Erasing a macro from MACRO 1 (or 2) button; Erasing all programmed commands and macros

Using the macro function
MACRO 1
m
V
SEND/LEARN
indicator
MACRO 2
MODE buttons
ENTER
I Erasing a macro from the MACRO 1 (or 2) button I
I
1. Press and hold down any one of the seven MODE
buttons, press the MACRO 1 (or 2) button, and then
release both buttons.
When you press the MODE button, it lights and the SEND/
LEARN indicator lights. When you press the MACRO 1 (or 2)
bullon, the indicator turns off. When you release the buttons, the
indicator flashes once.
2. Press the MACRO 1 (or 2) button again.
The SEND/LEARN indica/or slowly flashes twice. The macro
programmed to the MACRO button is erased.
No_s:
• If the SEND/LEARN indica/or quickly flashes three times and
turns off, then the remote controller has exited the erasing mode
because either you have made a mistake during erasing or a
time-out has occurred because no button has been pressed.
Resume from Slep I.
• lf you press a button other thanMACRO 1 (or2) button in Step
2, then you will in effect be overwriting the previous macro
with a new macro.
SEND/LEARN
indicator
STANDBY
_ _:_ ENTER
Erasing all commands and macros that have
been programmed
This procedure will erase all the commands and macros that you
have programmed into the remole controller and return it to its
default settings. This opera/ion will not affect the preset settings of
the remote controller.
1. Open the battery cover and remove the batteries from
the remote controller.
2. While pressing and holding down the ON and
STANDBY buttons, re-insert the batteries in their
correct orientation, and then release both buttons.
The SEND/LEARN indicator flashes slowly.
3. Press the ENTER button.
The SEND/LEARN indicator lights up for about ten seconds
and then turns off.
All programmed commands and macros are erased and the remote
controller returns to its factory presets.
Notes:
• Proceed to Step 3 immedialely after Step 2; otherwise, the
batteries will be consumed quickly.
• If you press any button other than the ENTER button in Step 3,
nothing will be erased. In this case, resume from Step 1.
74