Onkyo TX-SR701 - Input Setup; Select the desired input source; Digital Input settings

Input Setup
RETURN
AIVI_IP_
Input source buttons
RETURN
INPUT SELECTOR
bu_ons
SETUP
AIVI<I_
ENTER
This menu allows you to make the various sellings concerning the
signals input from the various input sources thai you use with the
TX-SR701/701E/601/601E. The sellings made in this menu are
valid for the input source that is currently selected with the input
source buttons at the front panel and, therefore, these settings are
made separately for each input source.
Setup Procedure
1. Select the desired input source.
2. Press the SETUP button on the front panel or SETUP
button on the remote controller.
The main menu appears.
1.Hardware Config
2.Speaker Config
3.Speaker Distance
4.Level Calibration
5.Input Setup
6.Preference
[[_i_IENTER]Quit:ISETUP I
[y.. .....
3. Use the • and • cursor buttons to select"5. Input
Setup" and then press the ENTER button.
The "Input Setup" menu appears.
Menu *****************
5.Input Secup
*** Inpuc:DVD *******
a.Diqical input :OP'PI_
b. Componenc Video
:lnputl_
c. IntelliVolume
0dB_
_ Quit:ISETUP ]
* Menu *****************
5.Inpuz Setup
*** Inpuc:DVD *******
e. PCM fs-96k
:Last Valid_
f.D.F. :Last Valid_
g.D.F.Mono:Last Valid_
_ Quit:ISETUP I
IL_. .rY)PtJ'{: gOPTi I2c',_ :L&_%Oa.i i,:i
4. Use the • and • cursor buttons to select an item and
then use the • and • cursor buttons to set the
desired value.
Press the RE'I URN button to return to the main menu.
Press the SETUP button on the front panel or SETUP button on the
remote controller to exit the Setup menu.
a. Digital Input
This setting tells the TX-SR701/701E/601/601E which input source
button on the fiont panel is connected with which digital input,jack
on the rear panel.
labr example, if the input source selemed at the front panel is CD
and the compact disc player is connecled to DIGITAL INPUT
OPTICAL 2, then select "OPT2" here. If the input source selected
is not connecled to a digital input, then select "'----?'
OPTI, 2: Select if the input source is connected to either of the
DIGrI'AL INPUT OPTICAL 1 or 2,jack.
COAX: Select if the input source is connected to the DIGrfAL
INPUT COAXIAL ,jack.
.... : Select if the input source is not from a digital input,jack.
The default settings are given below.
Input source Digital input
CD COAX
PHONO* ---
TAPE ....
DVD OPT I
VIDEO I ....
VIDEO 2 ....
VIDEO 3 OPT 2
.... : Available for digital input but not set in initial settings.
* TX-SR701/701E only
Notes:
• When you select "TUNER" for input, you cannot assign digital
input to "TUNER."
• Since VIDEO 4 is fixed to the optical digital lerminal on the
front panel, this item will be disabled if VIDEO 4 is selected.
52