Thermocode 2 Printer manual Version 2.04 January 2011 48
48
Error Codes
Error
Number
Error Message Reason Corrective Measures
5007
5008
5009
5010
Open Date
Loading Error
1. Noise down the
Communication Lead i.e.
Sending a Format or Font
when the Printer is booting
up.
2. Also Booting your
Computer & Printer at the
same time
1. Do not send to the Printer when booting up.
Other than Firmware. Reboot the Printer.
2. Boot the Computer Or Printer one at a time.
Not both together. Disconnect the Com’s Lead
from the
Printer
and reboot the Printer.
5011
Loading Error
Baud rate incorrect Check baud rate is same on computer and printer.
Note-:
Note 1: -
Spy chip fail
. When this message first appears this will read
“SPY chip fail 14”
This will allow the printer to run for 14 days decrementing each day to 0.
On the 14
th
day the message will read
“SPY chip fail 12, 2233, 0”
Everyday you will get an error message at approximately midday. This will happen until the
fourteen days are expired, or you change the Printhead.
For updates for the above Error Codes, refer to our Technical Web Site: - http://www.opendateinfo.com/
The first
error shown with in the Mini Terminal is the fault. Any other error faults shown on
the display, maybe generated because of this fault shown
.
12, 34,
To Next Page