DS-E Series（1~6KVA）User’s Manual
2
1.3 Performance Index
The main performance index of DS-E Series is shown in Table 1-1,Table 1-2.
Table 1-1 UPS Main Performance Index
Index Model DS1000E DS1000EL DS2000E DS2000EL DS3000E DS3000EL
Rating Voltage (V) 2X0V 160~275 Vac, 1X0V 80-138 Vac
Rating frequency (Hz) 50 or 60 (setup when leaving factory)
Input mode Single-phase three-line
Input
Characteristic
Battery voltage (V)
36 96(AC120V), 72(AC230V) 96
Capacity (VA) 1000 2000 3000
Voltage (V) 230±2%
Frequency (Hz) 50±0.2 (Battery mode)
Waveform Sine wave
Voltage distortion
factor
THD < 3% (Linear load)
Switching time (ms) 0
Overload capacity 105%~130% Load, lasting 60 seconds. 131%~150% Load, lasting 30 seconds.≥150%
lasting 300 milliseconds
Output Characteristic
Output mode Sockets Sockets and Terminal
Spare time
5 minutes
(PC LOAD)
Rational
configurati
on for long
time delay
5 minutes
(PC OAD)
Rational
configurati
on for long
time delay
5 minutes
(PC LOAD)
Rational
configuratio
n for long
time delay
Charge recovery time <12 hours (Standard time delay model)
Communication
interface
RS232 interface supports UPS power management software and SNMP protocol
Panel display LED displays operation status of UPS
Warning function Battery low voltage, abnormal power supply, UPS malfunction
Protection function Battery low voltage protection, overload protection, short-circuit protection and excess
temperature protection
Frequency noise (dB) < 45
Working temperature 0 ~ 40℃
Relative humidity 0 ~ 95%, No condensation
Size (mm)
(H × W × D)
225×155×465 347×198×490
Other Characteristics
Weight (kg) 15 8.5 32 17 38 18
◆ Specifications are subject to change without prior notice.
To Next Page
Loading...
