7 Installing drivers
7.1 USB-VCP drivers
To be able to communicate with the OPN200x terminals using USB-VCP, you will need to
have the USB driver installed on your PC. This driver can be found on our web site on the
'Service and Support' page.
www.opticon.com/SERVICE-AND-SUPPORT.aspx
The driver can be found in the section called 'Software' and then selecting the OPN200x on
the following page.
USB Drivers Installers.exe
USB-VCP driver for Windows 2000 , Windows XP (32bit) & Windows Vista/7 (32bit)
USB-VCP driver for Windows XP (64bit) & Windows Vista/7 (64bit)
USB driver for the CRD2002
After installing the USB driver, you can connect your OPN2002 or OPN2003 to USB using
the mini-USB cable. Windows will then automatically install a virtual COM port on your PC,
which can be selected in various applications, like Appload, Hyperterminal and Neto32.
7.2 CRD2000 cradle drivers (OPN2002 only)
The CRD200 cradle works either via USB or via RS232 and both interfaces do not require
any configuration.
The USB-VCP driver pack mentioned above also automatically installs the USB drivers for
the CRD2002 cradle.
To Next Page
Loading...
Need help?
General
