OPTIMUM
MASCHINEN - GERMANY
Maintenance
Version 1.0 dated 2015-05-27 Page 162 Original operating instructions
F3GB
Only qualified personnel should carry out maintenance and repair work on the CNC
machine.
Validation
Check and maintain all safety-relevant stop, control and measuring devices (validation).
Documentation
Record all tests and works in a operator's log resp. log book.
10.2.1 Preparation
WARNING!
Only carry out work on the CNC machine, if the main switch is switched off and secured
against restarting by means of a padlock.
"Disconnecting and securing the CNC machine“ on page 17
Attach a warning sign.
10.2.2 Restarting
Before restarting, run a safety check.
"Safety check“ on page 14
WARNING!
Before starting the CNC machine, you must check that there is no danger for persons
and that the CNC machine is not damaged.
To Next Page
Loading...
