OPTIMUM
MASCHINEN - GERMANY
Version 1.0.1 dated 2018-01-31 Page 63Translation of the original instructions
TM4010 | TM4010D GB
TM4010_TM4010D_GB_5.fm
When necessary
Tailstock
Readjust
If the tailstock clamping wears off. Shorten the clamping
distance by adjusting the nut below the tailstock.
weekly
Apron
Oiling
Lubricate all oiler cups with machine oil, do not use
grease guns or the like.
weekly
Lathe saddle / Cross slide /
Top slide / Lead screw /
Feed rod / Tailstock
at least annually
Cooling lubricant system
Replacing
Cleaning
Disinfect
"Inspection plan for water-mixed cooling lubricants“ on
page 66
based on operator's
historic values
in accordance with German DGUV (BGV A3)
Electronics
Electrical
inspection
"Obligations of the operating company“ on page 12
"Electronics“ on page 18
Interval Where? What? How?
To Next Page
Loading...
