OPTIMUM
MASCHINEN - GERMANY
Version 1.0.1 dated 2018-01-31 Page 9Translation of the original instructions
TM4010 | TM4010D GB
TM4010_TM4010D_GB_1.fm
1.3 Intended use
WARNING!
Improper use of the lathe will result in
will endanger personnel,
will endanger the lathe and other material property of the operator,
the correct function of the lathe may be affected.
The lathe is designed and manufactured for longitudinal and straight turning of round and regu-
lar formed
workpieces in cold metal, their diameter and weight are within the limits of the given specifica-
tions. The lathe must only be installed and operated in a dry and ventilated place.
The lathe is designed and manufactured to be used in environments where there is no poten-
tial danger of explosion.
If the lathe is used in any way other than described above, or modified without the approval of
Maschinen Germany GmbH, then the lathe is being used improperly.
We will not be held liable for any damages resulting from any operation which is not in accord-
ance with the intended use.
We expressly point out that the guarantee will expire, if any constructive, technical or proce-
dural changes are not performed by the company Optimum Maschinen Germany GmbH.
It is also part of the intended use that you
Warning: automatic start-
up!
Warning: tilting danger! Warning: suspended loads! Caution, danger of explo-
sive substances!
Switching on forbidden!
Do not climb onto the
machine!
Do not clean with com-
pressed air!
Read the operating instruc-
tions before commission-
ing!
Wear protective glasses! Wear protective gloves! Wear safety shoes!
Wear a protective suit! Use ear protection! Only switch when stopped! Protect the environment!
Contact address
To Next Page
Loading...
