Powering On the Projector
1. Remove the lens cap.
2. Securely connect the power cord and signal cable. When
connected, the power led will turn red.
3. Turn on the lamp by pressing
“ ” button on the side of the
projector or on the remote control. The power led will now
ash blue.
The startup screen will display in approximately 30 seconds.
The rst time you use the projector, you can select your
preferred language from quick menu after the startup screen
display.
4. Turn on your source that you want to display on the screen
(computer, notebook, video player, etc). The projector will
detect the source automatically and will display on the
screen. If not, push menu button and go to “SETUP”. Make
sure that the “Source Lock” has been set to “Off”.
▀■If you connected multiple sources at the same time, press
the “Source” key on the remote control to switch between
inputs.
Powering On/Off the Projector
Turn on the projector
rst and then select the
signal sources.
To Next Page
Loading...
