5
Workstation Accessories Setup and Use
This section contains instructions for setting up and using Workstation 8 Series accessories.
Customer Facing Display for Vertical Stand
1. Choose the location (left or right) on the Vertical Stand to mount the Customer Facing
Display.
2. Place the Customer Facing Display assembly against the Vertical Stand base, aligning
the captive screws with the corresponding holes in the stand.
3. Place the cable in the notch in the Vertical Stand base, and then tighten the Customer
Facing Display captive screws with the MICROS 2.5mm hex key or equivalent.
Figure 5-1 Mounting the Customer Facing Display on the Vertical Stand
4. Connect the cable to the Workstation 820 USB(CFD) port.
5. If you are adding a Customer Facing Display to an existing Workstation 8 Series
configuration with a Peripheral Expansion Module, connect the cable to the Peripheral
Expansion Module USB(CFD) port.
5-1
To Next Page
Need help?
General
