To attach the Customer Display with Pole Mount to a cash drawer or other surface with a
cable routing hole:
1. Tighten the pole base plate captive screws, if required. Guide the cable through cable
routing hole.
2. Attach the Customer Display with Pole Mount to the surface using the four #8-32 base
plate screws included in the Customer Display with Pole Mount box.
3. For configurations without the Peripheral Expansion Module, connect the Customer
Display with Pole Mount cable to the Workstation 820 USB(CFD) port.
4. For configurations with the Peripheral Expansion Module, connect the Customer Display
with Pole Mount cable to the Peripheral Expansion Module USB(CFD) port.
.
Chapter 5
Installing the Customer Display with Pole Mount on a Cash Drawer or Other Surface
5-5
To Next Page
Loading...