Mode Sense Command
August 2016 Commands 115
Read/Write Error Recovery Page
TABLE 3-71 Mode Sense Read/Write Error Recovery Page
Byte
Bit
76543210
0 PS SPF (0) Page Code (01h)
1 Page Length (0Ah)
2 Reserved TB RSVD EER PER DTE DCR
3 Read Retry Count
4
thru
7
(MSB)
Reserved
(LSB)
8 Write Retry Count
9
thru
11
(MSB)
Reserved
(LSB)
Parameter Value
PS: Parameters Savable 0 = Not supported
SPF: SubPage Format 0 = Mode page format
TB: Transfer Block 0 = Unrecoverable data block not transferred
EER: Enable Early Recovery 0 = Normal error recovery
PER: Post Error 0 = Normal mode
DTE: Disable Transfer on Error 0 = Normal mode
DCR: Disable Correction 0 = Always use error correction codes
Read Retry Count Extent of error recovery during read operations
64h = Default value, always maximum recovery
WriteRetry Count Extent of error recovery during the write operations
0h 5 minutes (same as default)
1h – 13h 10 seconds
14h – 3Bh 1 minute
3Ch – 63h 3 minutes
64h – 77h 5 minutes
78h – C7h 6 minutes
C8h – FFh 10 minutes
64h Default value (5 minutes)
To Next Page
Loading...
Need help?
General