Oracle StorageTek T10000 Reference Manual

Report Target Port Groups Command
August 2016 Commands 187
Target Port Group Descriptor Format
There shall be one target port group descriptor for each target port group.
TABLE 3-140 Target Port Group Descriptor Format
Byte
Bit
765432 1 0
0 PREF Reserved Asymmetric Access State
1 T_SUP O_SUP Reserved U_SUP S_SUP AN_SUP AO_SUP
2
thru
3
(MSB)
Target Port Group
(LSB)
4 Reserved
5 Status Code
6 Vendor Specific
7 Target Port Count
Target Port Descriptors
8
thru
11
(MSB) Target Port Descriptor (First)
(See TABLE 3-141 on page 188)
(LSB)
n-3
thru
n
(MSB)
Target Port Descriptor (Last)
(See TABLE 3-141 on page 188)
(LSB)
Parameter Value
PREF 1 = Preferred target port
AAS Asymmetric Access State
0 = Active / Optimized
T_SUP 0 = Not supported
O_SUP 0 = Not supported
U_SUP 0 = Not supported
AN_SUP 0 = Not supported
AO_SUP 1 = Active / Optimized is supported
Target Port Group 1 = Target port group identification
Status Code 0 = No status available
Vendor Specific 0 = Not supported
Target Port Count 2 = Number of target ports

Oracle StorageTek T10000 Specifications

General

Brand	Oracle
Model	StorageTek T10000
Category	Storage
Language	English