Request Sense Command
194 T10000: Interface Reference Manual August 2016
Additional Sense Codes and Qualifiers
TABLE 3-147 lists the Additional Sense Code and Qualifiers found in Bytes 12 and 13
of the sense data. These codes provide additional information about an error.
TABLE 3-147 Sense Key with ASC and ASCQ
Key
Byte
Description12 13
0 00 00 No additional sense information
00 01 Filemark detected
00 02 End of partition/medium detected
00 04 Beginning of partition/medium detected (read or space reverse into BOT)
00 17 Cleaning requested
00 18 Erase operation in progress
00 1C Verify operation in progress
5B 02 Log counter at maximum
2 04 01 Logical unit is in the process of becoming ready (load immediate cmd.)
04 03 Logical unit not ready, manual intervention required (drive is offline)
30 03 Cleaning cartridge installed (cleaning)
3A 00 Medium not present
53 00 Media load or eject failed
3 00 02 End of partition/medium detected
0C 00 Write error (write data check)
11 01 Read retries exhausted (read data check)
11 02 Error too long to correct
11 0E Decompression failure (can’t decompress using this algorithm)
14 04 Block sequence error (block ID in record header was out of sequence)
15 00 Random positioning error
26 05 Data decryption error
30 00 Incompatible medium installed (tape too long)
30 01 Cannot read medium, unknown format (density ID read failed)
30 02 Cannot read medium, incompatible format (illegal data format)
31 00 Medium format corrupted (cannot write density ID)
33 00 Tape length error (short tape error)
3B 00 Sequential positioning error
3B 01 Tape position error at beginning-of-tape
3B 08 Reposition error (CU ERP failed and we are lost)
51 00 Erase failure (long erase check)
To Next Page
Loading...
Need help?
General