Replacing a ZS3-2 Battery
6.
Lift the battery out of the receptacle and set it aside.
7.
Position the battery where it will install into the receptacle, with the positive (+)
side of the battery facing up.
8.
Press the battery into the receptacle until you hear a click.
9.
Install Riser 1.
10.
Replace the top cover and tighten the two captive screws.
11.
Push the release tabs on the side of each rail and slowly push the storage
controller into the rack, making sure no cables obstruct the path of the
controller.
12.
Reconnect all cables to their original ports, referring to the labels previously
added as a guide. For cabling details, see the Oracle ZFS Storage Appliance
Cabling Guide.
13.
Connect the power cords to the power supplies. Verify that standby power is on,
indicated by the Power/OK and SP status indicators flashing green on the front
panel.
14.
After the SP status indicator is solid green, use a pen or other pointed object to
press and release the recessed Power button on the front panel. The Power/OK
status indicator next to the Power button lights and remains lit.
Servicing the ZS3-2 Controller 155
To Next Page
Loading...
Need help?
General