Oracle ZFS ZS3 Series - Page 342

Resolving Health Check Alerts
1.
If a SAS port LED is unlit, check all connections and replace cables as needed.
2.
Identify affected chassis, then disconnect and remove faulted SIM or IOM.
After two minutes, re-seat SIM or IOM and wait for steady Power LED before
reconnecting cables.
3.
Identify affected chassis, and remove faulted disk. After 30 seconds, re-seat disk
and wait for steady or flashing LED.
4.
Contact Oracle Support for component service or replacement.
342 Oracle ZFS Storage Appliance Customer Service Manual • July 2016